My Babysense Maxview parent unit turns off!

Unprompted, your Babysense babysense split screen monitor turns off, without warning...

Finding a clear and simple solution is all you need.

Try the following:

  • It could be that the Babysense power adapter is not working properly and thus hasn’t charged. Note: It takes approximately 8 hours for the battery to fully charge.
  • Switch between the power adapters of the Maxview camera and parent units.
  • If that solves the issue, then the problem is with the power adapter.
  • If the issue persists, disconnect the cameras and parent unit from the power adapters, try to reset the monitor by inserting a sharp pin into the reset hole at the back of the parent unit (underneath the antenna).

If you are still unsuccessful, let our Babysense Support Team know. 

Was this article helpful?

0 out of 1 found this helpful

Have more questions? Submit a request